Underwriters Laboratories Network IR Speed Dome Camera Manual de instalación descargar pdf (Pagina 30)

IR Speed Dome Installation Manual

4.2 Corner Mounting Instructions

The corner mounting is applicable to the indoor/outdoor 90° solid corner construction which should comply with the following

mounting requirements:

 The wall must be thick enough to install the expansion screws.

 The wall must be capable of supporting up to 8 times the total load of the dome and its accessories.

Step1: Install the corner mount

Drill four holes in the corner according to the mounting locations, and then insert M6 expansion screws (not supplied) into the holes.

Pull the power cord, video cable and control line through the opening of the corner mount. Secure the corner mount to the corner by

using nuts and washers to tighten the four expansion screws.

Note: Make sure the cables have enough length. For outdoor applications, please apply the sealant around the cable opening to prevent

water.

Step2: Secure the wall mount to the corner mount

To fix the wall mount to the corner mount, screw 4 hexagonal screws with the spring washers through the wall mount and gaskets then

into the corner mount.

Note: It is better to rotate the screw semicircle more after the spring washers have been compressed tightly so as to develop the seal

function of gasket without damaging the screw thread.

1 2 ... 25 26 27 28 29 30 31 32 33 34 35 ... 39 40

Sin comentarios

Underwriters Laboratories Network IR Speed Dome Camera Manual de instalación Pagina 30