
1-1
Introduction
Overview
The VideoEdge
®
IP SpeedDome Camera (hereafter referred to as IP Dome) operates across an IP
network, e.g. the Internet, a LAN or WAN. The video output from the camera is compressed and
sent across the network using IP transport mechanisms. PTZ camera control outputs from IP-
connected controllers will be passed to the dome control electronics, allowing complete
functionality as existing domes at a remote location connected by any kind of IP network.
A built-in web server provides web pages to configure the domes and streams the video using a
customer-selected set of protocols with a standardized transport stream. This will also support
other metadata and audio as required. Emails and movie clips (avi) may be sent across the
network in response to alarms. The IP Dome can operate as a stand alone camera on a network
however it is intended to be integrated into sophisticated security solutions.
The IP Dome is available in four models:
•35X PAL
•35X NTSC
•22X PAL
•22X NTSC
The IP Dome can be used with a proprietary Network Video Recording device, for example the
VideoEdge
®
NVR or Intellex IP.
The maximum number of streams currently supported is four. When using Intellex Direct Protocol
(IDP) a maximum of two streams are supported, running ACC from the WebGUI or ACC from an
network video recording device. When using Real Time Streaming Protocol (RTSP) a maximum of
two streams are supported running MJPEG and MPEG4 or H.264.
Comentarios a estos manuales